This is a quick stand I made to display some Shopkins. A little rough around the edges, will possibly work on a new version that's stackable somehow or will print better with less supports.
Could probably be re-designed to use less material as well.
UPDATED v2 (9/30/17): refined the design a bit. Prints vertically with no supports, rounded off some of the edges, stand is thinner and spacing between pegs minimized to use less material.
Disclaimer: this is meant to be used by kids as a toy. While it has no small parts that may be swallowed, and I have rounded off any square edges, please exercise some common sense with this or any other 3d printed toy that may be subject to breaking or imperfections.
Printer Brand:
Prusa
Printer:
Prusa Clone
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
20%
Notes:
Prints vertically as of v2. Make sure your x/y axis belts are nice and taut since it's a tall print.
