I made this model from my Fatalis model and the Castle dice tower by LennartS. It was an idea a got by talking with a friend about dice towers with dragons. Because of the print volume on my printer, I can't print it one piece in full size so I printed it 57%. Because of that I'll try to split it to seperate pieces later. If you print this in full size, I would love to see the finished product.
Printer Brand:
Duplicator 4
Printer:
Wanhao
Rafts:
No
Supports:
Yes
Resolution:
0.3 mm
Infill:
10%
Notes:
because you don't want the support inside, i would recomend uing a software with custom support option. I sliced it with simplify3D. You could also make some custom support mesh in any 3D modeling software, but i'm not an expert on that. its mostly the wings and head that needs support.
I uploaded the tower model into blender. then i imported my rigged fatalis model and just posed it around the tower. After that a applied all modifires and did some final sculpting to make it as printable as posible.
